DHC-AZ55D/AZ33D.GB.3-215-548-11(1)
118
GB
Tuner
The radio presetting is canceled.
e power cord is disconnected or a
power failure occurred for longer than
a day. Redo “Listening to a preset radio
station” (page 70).
There is severe hum or noise.
(“TUNED” or “STEREO” ashes in the
display)
Set the proper band and frequency
(page 70).
Connect the antenna properly
(page 21).
Find a place and an orientation that
provide good reception, then set up
the antenna again. If you cannot obtain
good reception, we recommend that
you connect a commercially available
external antenna.
e supplied FM lead antenna receives
signals along its entire length, so make
sure you extend it fully.
Locate the antennas as far away from
the speaker cords and the power cord
as possible, to avoid picking up noise.
Try turning o the surrounding
electrical equipment.
A stereo FM program cannot be
received in stereo.
Press REPEAT/FM MODE
repeatedly until “MONO” disappears
from the display.
Tape deck
The tape does not record or
playback, or there is a decrease in
sound level.
e tape heads are dirty (see “Cleaning
the tape heads” (page 124)).
e record/playback heads are
magnetized (see “Demagnetizing the
tape heads” (page 124)).
The tape does not erase completely.
e record/playback heads are
magnetized (see “Demagnetizing the
tape heads” (page 124)).
There is excessive wow or utter, or
the sound drops out.
e capstans or pinch rollers are dirty
(see “Cleaning the tape heads” (page
124)).
Noise increases or the high
frequencies are erased.
e record/playback heads are
magnetized (see “Demagnetizing the
tape heads” (page 124)).
The tape does not record.
No tape is loaded. Load a tape.
e tab has been removed from
the tape. Cover the broken tab with
adhesive tape (page 124).
e tape has reeled to the end.
To Next Page
Loading...
Need help?
General
