32
You can change the default settings using the (Setup) screen.
1 Turn on the power.
2 Press MENU to display the menu.
3 Move the multi-selector to B to select (Setup), then move the multi-
selector to B.
4 Move the multi-selector to v/V/b/B to
select the item you want to set.
The frame of the selected item turns yellow.
5 Press the center of the multi-selector to enter the setting.
To turn off the (Setup) screen, press MENU.
To return to the menu from the (Setup) screen, move the multi-selector to b repeatedly.
z When the menu is not displayed
Pressing down MENU for about 1.5 seconds turns the (Setup) screen on.
To cancel the (Setup) setting
Select [Cancel] if it appears, then press the center of the multi-selector. If it does not appear,
select the previous setting again.
• This setting is maintained even when the power is turned off.
Using the (Setup) screen
Mode dial
Multi-selector
MENU button
To Next Page
Loading...
