Sony DSC-R1 User Manual

61
Enjoying the camera
Monitor mode setting
When you shoot under fluorescent light, flicker may occur on the screen depending on
regions. You can reduce that flicker.
Set the MONITOR switch to the desired mode.
When the flicker is not reduced in [FRAMING] mode
Normally, the camera automatically detects the flickering cycle and reduces the flicker.
However, if it is not detected properly, set the power supply frequency (50Hz/60Hz) of your
region beforehand. The flicker will be reduced.
1 Display the (Setup) screen (page 32).
2 Select (Camera 2) by moving the multi-selector to v/V, [Flicker Reduction] by moving to
B/v/V.
3 Select the desired mode by moving to B/v/V, then press the center of the multi-selector.
( : The default setting)
Reducing flicker
P S A M
FRAMING
Reduces the flicker.
To confirm the subject, the screen is brighter while monitoring
(Auto Bright Monitoring).
PREVIEW
Does not reduce the flicker.
Before shooting, you can confirm the depth of field (page 38).
Starting time and shutter lag time are shorter than that of
[FRAMING] mode.
60Hz
For regions where the power supply frequency is 60 Hz.
50Hz
For regions where the power supply frequency is 50 Hz.
Auto
The camera automatically detects the power supply
frequency: 50 Hz or 60 Hz.
MONITOR
FRAMING PREVIEW
Multi-selector
MENU button
MONITOR switch
2

Sony DSC-R1 Specifications

General

Sensor Type	CMOS
Sensor Size	21.5 x 14.4 mm
Effective Pixels	10.3 Megapixels
Lens	Carl Zeiss Vario-Sonnar T*
Focal Length	24-120 mm (35mm equivalent)
ISO Sensitivity	160-3200
Shutter Speed	30 - 1/2000 sec
Image Formats	JPEG, RAW
Battery	NP-FM50 InfoLithium rechargeable battery
Weight	995 g (including battery)
Aperture Range	f/2.8-4.8
LCD Screen	2.0-inch, 134, 000 pixels
Viewfinder	Electronic (EVF), 235, 000 pixels
Storage Media	CompactFlash, Memory Stick
Dimensions	139 x 97 x 156 mm
Camera Type	Digital SLR-like camera