Sony DSC-R1 - Shooting Three Images with the Exposure Shifted - Exposure Bracket

44
In addition to an image with the exposure automatically set by the camera, two other images
are recorded with exposure values shifted to the + and – sides.
If you cannot shoot with the proper brightness due to the brightness of the subject, use the
Exposure Bracket mode. You can select the image that has a suitable exposure after shooting.
1 Press and hold /BRK (Bracket) and turn the main command dial to select [BRK].
2 Press MENU.
3 Select [BRK] (Bracket Step) by moving the multi-selector to b/B, then select the desired
bracket step value by moving to v/V.
( : The default setting)
• The flash is set to (No flash).
• The focus and white balance are adjusted for the first image, and these settings are also used for the other
images.
• When the exposure is manually adjusted (page 41), the exposure is shifted based on the adjusted
brightness.
• The recording interval is approximately 0.32 second.
• If the subject is too bright or too dark, you may be unable to shoot properly with the selected bracket step
value.
Shooting three images with the exposure shifted
– Exposure Bracket
P S A M
±1.0EV
Shifts the exposure value by plus or minus 1.0EV.
±0.7EV
Shifts the exposure value by plus or minus 0.7EV.
±0.3EV
Shifts the exposure value by plus or minus 0.3EV.
Correct
– direction
30 F2.8
-2 2+1 0 1
Normal BRK
BRK
0.7
EV
BRK
+
/BRK button
Main command dial
Multi-selector
MENU button
+ direction