Fordetai/sontheoperation _ page80
• When cleaning the CCD, do not put the tip of a blower brush into the cavity
beyond the lens mount, You do not need to put the blower brush close to the
CCD.
(_) Attach the lens and set the POWER s_xitch to OFF.
• The camera starts beeping if the baiteD' pack becomes low during cleaning. Stop the cleaning immedialely
and sel the POWER switch 1o OFE
"_" To keep dust from entering the camera
While il is impossible to completely shul out dust, tile lollowing reminders should help lower tile possibilily.
• Choose a location wilh lillle dusl 1£_change the lens. and complele lhe operation quickly.
• Do nol leave lhe camera without a lens or tile body cap.
• When atlaching tile body cap. remove all lhe dust honl lhe cap belkll-eplacing il on lhe camera.
You Call reset the mailt ftlnctions of the camera.
(_) Select [Enter] in [Reset default].
The message "Reset default?" appears.
(_ Select [Yes] with _1on the controller, then press the center of the controller.
The main lhnctions are rescl.
• For details on the items to be resel, see "Resel del_mll" (page 151).
104
To Next Page
Loading...
