Readthis first
Replace tile battelT with the specified type
only. Otherwise, tim or injury may result.
RECYCLINGLITHIUM-IONBATTERIES
Lithiuln-lon batteries are
recyclable.
You can hel l) preserve our
environlllent by returlling your
used rechargeable batteries to
the collection and recycling
location nearest you.
For nlom intomlation regarding recycling of
rechmgeable batteries, call toll flce
1-81R1-822-8837. or visit http://www.rbrc.org/
Caution: Do not handle dalnaged or leaking
Lithium-Ion batteries.
If you have any questions about this product, you
may call:
Sony (-'uslomer hlR)rlnation Services ('elller
1-800-222-SONY (7669)
The number below is R)r the FCC related mailers
only.
RegulatoryInformation
Declaration of Conformity
Trade Name: SONY
Model No.: DSLR-A100
Responsible Party: Sony Electronics Inc.
Address: 16530 Via Esprillo.
San Diego. CA 92127 U.S.A.
Tdephone No+: 858-942-2230
This device conlplies with Part 15 of tile FCC
Rules. Operation is subject to the tollowing
two conditions: (1) This device may not cause
harmhll interllrrence, and (2) this device must
accept any interlcrence received+ including
interlhrence that nlay cause undesired
operation,
CAUTION
You are cautioned that any changes or
znodilicationsnot expressly approvedin ttlis
manual couM void your autllority to operate this
equipment.
Note:
This equipment llas been tested and fimnd to
comply wfill tile liznits lor a Class B digital
dexice, pUl',uant to Part 15 of tile FCC Rules.
Thee limits are designed to provide reasonable
protection against llarmlul inlerlcrcncc in a
residential installation. This equipment generates,
uses, and can radiate radio fiequency energy and.
if not installed and used in accordance wifll the
instructions, may cause harlnhll interlhrcnce to
radio COlllnl/llliCatiollS. Howe,, er, there is 11o
guarantee that intcrli:rcnce will not occur in a
particular installation. If this equipment does
cause harnlful intedcmnce to radio or television
reception, which can be deternlined by turning the
equiplncnt off and on, the user is encouraged to
try to correct tile illterl_rcnce by one or ii]ort2of
the R_llowing measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and rcceivel:
(-'onnect tile equipment into an outlet on a
circuit ditlhrent h-olil that to which the
receiver is connected.
Consult tile dealer or an experienced radio/TV
technician fi)r help.
To Next Page
Loading...
Need help?
General
