The supplied interlace cable must be used with file
equipment in order to conlply with tile limits klr a
digital device pursuant to Subpart B of Part 15 of
FCC Rules.
FortheCustomersintheU.S.A.and
Canada
THIS DEVICE COMPLIES WITH PART 15 OF
THE FCC RULES. OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE. AND (2) THIS
DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVE[). INCLUDING
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
THIS CLASS B DIGITAL APPARATUS
COMPLIES WITH CANADIAN ICES-fi03.
This product has been tested and %und compliant
with tile lilnits set ouI in the EMC Directive lor
using connection cables shorter than 3 meters (9.8
leet).
Attention
Tile electrolnitgnetic fields ilt tile specific
lrequencies may influence the picture and sound
of this unit.
Notice
If St_ltiCelectricity or electromilgnetisnl ca/ises
data translPr to discontinue midway (l,fil), restart
tile application or disconnect and connect the
comnmnication cable (USB, etc.) again.
Disposalof Old Electrical& Electronic
Equipment(Applicableinthe
EuropeanUnionand other European
countrieswith separatecollection
systems)
This symbol on the product or on its packaging
indicates that fllis product shall not be treated as
household waste. Instead it shall be banded over
to the applicable collection point lor file recycling
of electrical and electronic eqlfipmenL By
ensuring fills product is dispo_d of correctly, you
will help prevent potential negative con_quences
fin"tile environment and Imman health, which
could otherwise be caused by inappropriate waste
handling of this product. The recycling ol
materials will help to conselwe natural resources.
For more detailed inklrmation about recycling of
this product, please contact your local Civic
Office, your household waste disposal service or
tile shop where you purchased the product.
A moulded plug complying with BS 1363 is fitted
to lifts equipment lor your salcty and convenience.
Should the fllse in the plug supplied need to be
replaced, a filse of the same rating as the supplied
one and approved by ASTA or BSI to BS 1362.
(i.e., marked with an @ or _ mark) must be
used.
If the plug supplied with this equipment has a
detachable luse cover, be sum to attach the luse
cover afier you change the lilse. Never use file
plug without the filse cover. If you should lose the
Iilse cover, please contact your nearest Sony
service station,
To Next Page
Loading...
Need help?
General
