If you cannot connect to a network correctly, the following reasons are possible. Try the
connection again or use another connection method.
You pressed the WPS button more than two minutes after selecting [Start] in step 4.
The WPS button may have to be pressed and held for about two minutes (depending on the router).
You cannot cancel the connection after the HDD AUDIO PLAYER has started connecting to
the network.
Do not turn the power off while the HDD AUDIO PLAYER is connecting to the network.
Hint
For details on the name and position of the WPS button on your wireless LAN router/access
point, refer to the operating manual of the router/access point.
[32] Wi-Fi network connections (wireless LAN)
Method 2. Setting up a network connection by selecting an
access point
You can set up a Wi-Fi (wireless LAN) network connection by searching for an access point.
Note
This connection method requires information such as the network name (SSID) (*1) of the
wireless LAN router/access point and the security key (password) (*2) for the network.
*1
SSID (Service Set Identifier) is a name that identifies a particular access point.
*2
This information should be available from a label on your wireless LAN router/access point, from the
operating manual, from the person who set up your wireless network, or from the information provided by
your Internet service provider.
1. Select [Settings] - [Network Settings] - [Internet Settings].
2. Select [Wireless Setup].
3. Select [Select access point].
The HDD AUDIO PLAYER starts searching for available access points.
4. When the list of available network names (SSID) is displayed, select the access point you
want to connect to.
An input space for a security key (WEP/WPA) appears on the screen.
If you have selected an access point with no security key, proceed to step 8.
5. When the input space for the security key (WEP/WPA) is surrounded by a white box, push
the jog dial in.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
