Sony HAP-S1 User Manual

Device configuration
Signal conditions
Surrounding environment (wall material, etc.)
Software in use
Communications may be cut off depending on signal conditions.
The HDD AUDIO PLAYER does not support 5 GHz band Wi-Fi.
The data transfer rate for IEEE 802.11g and IEEE 802.11n (2.4 GHz) devices may be
affected by interference when used with IEEE 802.11b products. Also, products using IEEE
802.11g and IEEE 802.11n automatically lower the transfer rate to maintain compatibility with
IEEE 802.11b products. The normal transfer rate may be regained by changing the channel
settings of your access point.
When the data transfer rate is not as fast as expected, changing the wireless channel on the
access point may increase the rate.
If a communication failure occurs while transferring music files, updating the firmware of your
access point may improve the communication status.
[30] Wi-Fi network connections (wireless LAN)
Selecting a Wi-Fi (wireless LAN) connection method
You can select the most suitable network connection method for your network environment
from 4 network connection methods. Confirm your network environment in advance.
If your wireless LAN router/access point supports the WPS (Wi-Fi
Protected Setup) push button configuration method
If your wireless LAN router/access point has a designated WPS button, you can connect to a
Wi-Fi (wireless LAN) network by a single press of a button. Refer to the following link for details.
Method 1. Setting up a network connection using the WPS push button
configuration method
If setting up a network connection by searching your access point
You can search for available access points that are already configured and select a network
name (SSID) from the search results.
Confirm the network name (SSID) and security key (WEP key or WPA key) of your wireless
LAN router/access point in advance, then refer to the following link for details.
Method 2. Setting up a network connection by selecting an access point
If connecting to a new access point
You can add and connect a new access point by entering a network name (SSID) and security

Sony HAP-S1 Specifications

General

Product color	Silver
Audio formats supported	AAC, AIFF, ALAC, FLAC, LPCM, MP3, WAV, WMA
Impedance	16 Ω
Frequency range	10 - 100000 Hz
Audio output channels	2.0 channels
Signal-to-Noise Ratio (SNR)	100 dB
Channels quantity	2 channels
Wi-Fi	Yes
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Automatic synchronization	You don't have to change personal settings when first connecting your device. Your device is automatically synchronized with the settings of your car, so once you have done it for the car, that's it!
Storage media type	HDD
Total storage capacity	500 GB
HDCP	No
Headphone outputs	1
USB 2.0 ports quantity	2
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	0
AC input voltage	230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.3 W
Display diagonal	4.3 \

Weight and Dimensions

Width	- mm
Weight	- g