Sony HAP-S1 User Manual

1. Press and hold on the HDD AUDIO PLAYER for 5 seconds or more.
The power lamp flashes three times and then the power turns off.
After a while, the HDD AUDIO PLAYER is automatically rebooted and enters the standby
mode or the Network Standby mode.
Note
If you forcibly shut down the HDD AUDIO PLAYER while music files are being transferred,
the files or setting configurations may not be saved in or applied to the HDD AUDIO
PLAYER.
[93] Dealing with problems/Inquiries
Messages for protecting the HDD AUDIO PLAYER
If the HDD AUDIO PLAYER detects an abnormality inside the unit, one of the following
messages appears for about 5 seconds and then the HDD AUDIO PLAYER automatically
enters the standby mode.
Note
The HDD AUDIO PLAYER enters the normal standby mode, even if the Network Standby
mode is set to [On].
The next time you turn the power on, the volume will be at the minimum.
AMP PROTECTOR
The internal temperature of the HDD AUDIO PLAYER is too high. Turn the power off, remove
any objects covering the ventilation holes and then turn the power on again.
HDD PROTECTOR
The internal temperature of the HDD AUDIO PLAYER is too high. Turn the power off and
remove any objects covering the HDD AUDIO PLAYER. Wait until the HDD AUDIO PLAYER
cools down sufficiently and then turn the power on again.
USB PROTECTOR
An abnormal current is being output to the EXT port on the rear of the HDD AUDIO PLAYER.
Turn the power off, confirm the connection and then turn the power on again.
CPU PROTECTOR
The internal temperature of the HDD AUDIO PLAYER is too high. Turn the power off and
remove any objects covering the HDD AUDIO PLAYER. Wait until the HDD AUDIO PLAYER
cools down and then turn the power on again.

Sony HAP-S1 Specifications

General

Product color	Silver
Audio formats supported	AAC, AIFF, ALAC, FLAC, LPCM, MP3, WAV, WMA
Impedance	16 Ω
Frequency range	10 - 100000 Hz
Audio output channels	2.0 channels
Signal-to-Noise Ratio (SNR)	100 dB
Channels quantity	2 channels
Wi-Fi	Yes
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Automatic synchronization	You don't have to change personal settings when first connecting your device. Your device is automatically synchronized with the settings of your car, so once you have done it for the car, that's it!
Storage media type	HDD
Total storage capacity	500 GB
HDCP	No
Headphone outputs	1
USB 2.0 ports quantity	2
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	0
AC input voltage	230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.3 W
Display diagonal	4.3 \

Weight and Dimensions

Width	- mm
Weight	- g