Sony HAP-S1 User Manual

5. When rescanning of the hard disk drive is complete, select [OK].
Note
Performing the Rescan HDD functions (except for the differing items scan) restores the
information of the music files. Music information edited by HDD Audio Remote is therefore
reset. However, playlist information (playback times, newly added, playlists made by HDD
Audio Remote), the favorite status ( ) and edited SensMe™ channels information are kept.
When starting to rescan the hard disk drive, playback of music files stops.
If no external hard disk drive is connected, [Rescan External HDD] and [Rescan External
HDD (differing items)] are disabled and grayed out in step 3.
Do not turn the HDD AUDIO PLAYER off during rescanning.
Do not disconnect the external hard disk drive during rescanning.
You cannot operate the HDD AUDIO PLAYER during rescanning.
Hint
If you use a computer to add or delete music files on an external hard disk drive that was
previously connected to the HDD AUDIO PLAYER, then connect the external hard disk drive
to the HDD AUDIO PLAYER again, perform [Rescan External HDD (differing items)].
Rescanning for differing items keeps music information, playlist information, the favorite
status ( ) and edited SensMe™ channels information on the music files other than those
that were added/deleted.
Formatting an external hard disk drive (Format External
HDD)
You can format an external hard disk drive.
After formatting, all of the content stored on the hard disk drive is deleted.
If formatting an external hard disk drive, be sure to confirm that it is connected properly.
1. Select [Settings] - [HDD Settings] in the Home screen.
2. Select [Format External HDD].
A confirmation screen appears.
3. Select [Yes].
Formatting of the hard disk drive starts.
4. When formatting of the hard disk drive is complete, select [OK].

Sony HAP-S1 Specifications

General

Product color	Silver
Audio formats supported	AAC, AIFF, ALAC, FLAC, LPCM, MP3, WAV, WMA
Impedance	16 Ω
Frequency range	10 - 100000 Hz
Audio output channels	2.0 channels
Signal-to-Noise Ratio (SNR)	100 dB
Channels quantity	2 channels
Wi-Fi	Yes
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Automatic synchronization	You don't have to change personal settings when first connecting your device. Your device is automatically synchronized with the settings of your car, so once you have done it for the car, that's it!
Storage media type	HDD
Total storage capacity	500 GB
HDCP	No
Headphone outputs	1
USB 2.0 ports quantity	2
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	0
AC input voltage	230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.3 W
Display diagonal	4.3 \

Weight and Dimensions

Width	- mm
Weight	- g