HBD-E280/T28
19
6. The message “Close” appears, and press the [ ] button on the
remote commander.
Initialize Personal Information
Close
Initialization complete.
7. Select “Reset to Factory Default Settings”, and press the [ ]
button on the remote commander.
Initialize Personal Information
Reset to Factory Default Settings
Restore each setting to the factory d
8. Select “All Settings”, and press the [ ] button on the remote
commander.
Reset to Factory Default Settings
BD/DVD Viewing Settings
Personal Control Settings
Music Settings
System Settings
Network Settings
All Settings
9. Select “Start”, and press the [ ] button on the remote com-
mander.
All Settings
Restore all settings to the factory default
settings. The system will turn off after
reset.
Start
Cancel
10. Initialization ends when the message “WELCOME” on the
fl uorescent indicator tube disappears.
BD SERVICE MODE
[Wireless checking fail on M07.R.179]
Due to software bug in M07.R.179, currently Service mode do not sup-
port wireless checking features this version of software. For service to
confi rm the wireless checking, please update customer sets to latest ver-
sion of software. By using network upgrade method or Disc upgrade
method. After fi nish upgraded, Service member can perform wireless
checking as mention in wireless LAN checking pages.
Or
Confi rm wireless LAN connection from customer mode, in case of
Wireless connection successfully establish. The wireless Lan network
connection will be judge as OK.
Date: 26 January 2011
Note: The operation in this mode must use a remote commander and TV
monitor.
Setting method of the BD service mode:
1. Connect this unit with TV monitor.
2. Press the [
?/1
] button to turn the power on.
3. Press button in order of the [DISPLAY] → [0] → [2] → [1] →
[SUBTITLE] on the remote commander. (Make the interval
when each button is pressed within two seconds)
4. Enter the BD service mode. The OSD menu on TV monitor
can be operated by remote commander.
1. Main Functions
• Diag
Performs unit test of devices installed on the board.
• Display Error Log
Error log is displayed. Displayed contents can also be saved in
an USB memory device.
• Factory Initialize
Restores the unit to its factory settings.
• Network
Checks the wired network connection.
• Version Up
Not used.
• System Information
Displays the system information of the unit.
Displays information such as the software version, drive infor-
mation, etc.
• EMC Test Mode
Not used.
• Drive
Write drive OP data and check drive.
To Next Page
Loading...
