13
HCD-HPR90/HPR99XM
CD SERVICE MODE
This mode can run the CD sled motor freely. Use this mode, for
instance, when cleaning the optical pick-up.
Procedure:
1. Press the I/1 button to turn the power on.
2. Press the [CD] or [FUNCTION] key on the remote commander
to select “CD”.
3. Press three buttons of [PUSH ENTER], [DSGX] and [DISC 1]
simultaneously, the message “SERVICE IN” is displayed on
the fluorescent indicator tube.
4. Press the M L button to move the optical pick-up to outside
track and the message “SLED OUT” is displayed on the
fluorescent indicator tube, or press the l m button to
inside track and the message “SLED IN” is displayed on the
fluorescent indicator tube.
5. Press the x button, “LD OFF” is displayed and laser diode is
turned off. Each time x button is pressed, laser diode ON/
OFF switch is performed.
6. To release this mode, press the I/1 button.
TUNER STEP CHANGE-OVER
A step of AM tuning interval can be changed over between 9 kHz
or 10 kHz.
Procedure:
1. Press the I/1 button to turn the power on.
2. Press the [TUNER/BAND] button to select “AM”.
3. Press the I/1 button again to turn the power off.
4. Press two buttons of M L and I/1 simultaneously.
5. The message “STEP 9kHz” or “STEP 10kHz” is displayed on
the fluorescent indicator tube and thus the tuning interval is
changed over.
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
