Help Guide
IC Recorder
ICD-UX570F / ICD-UX575F
You cannot charge the battery by connecting the IC recorder to your computer.
When your IC recorder is connected to a computer which is not running, the battery will not charge. When the
computer is in a power saving mode (standby or sleep), it will not charge, either.
Disconnect your IC recorder from the computer and connect it once again.
Check the system requirements of your IC recorder.
Charge the battery under the temperature of 5 °C - 35 °C.
If your IC recorder is connected to the computer with a USB hub (commercially available) or a USB extension cable
(commercially available), remove the hub or cable and connect the IC recorder directly to a USB port on the
computer.
Related Topic
Charging the battery with a computer
System requirements
5-006-945-11(1) Copyright 2019 Sony Corporation
To Next Page
Loading...
