Sony ICD-UX575F - Recording Automatically in Response to the Input Sound Volume - the vor Function

Help Guide
IC Recorder
ICD-UX570F / ICD-UX575F
Recording automatically in response to the input sound volume – the VOR function
You can set your IC recorder to automatically start when the input sound volume reaches the predefined level, and
pause when the volume decreases below the level.
When the input sound volume decreases below the predefined level, flashing
appears and the
recording pauses. When the volume reaches the level once again, the recording restarts.
Note
The VOR function is affected by the ambient sound conditions. Select the sensitivity level of the built-in microphones suitable to
your ambient sound conditions. For instructions on selecting the sensitivity level, see Selecting the sensitivity level of the built-in
microphones (Built-In Mic Sensitivity).
If the selected sensitivity level does not work as you expected or when you want to make an important recording, follow the above
steps to set [VOR] to [OFF].
During synchronized recording and FM radio recording, the VOR function does not work.
Hint
To cancel the VOR function setup process, set [VOR] to [OFF] in step 2.
Related Topic
Recording audio from an external device with the synchronized recording function (SYNC REC)
5-006-945-11(1) Copyright 2019 Sony Corporation
While recording is on standby, in progress, or paused, select [VOR] on the OPTION menu, and then press
(play).
1
Press
(move up) or (move down) to select [ON], and then press (play).
[VOR] is set to [OFF] by default.
2
Press
REC/PAUSE.
appears on the display window.
3
71