— 31 —
27
Playing an MD
POWER AMS
1
Turn on the mixer.
2
Adjust the fader or level of the connected channel
of the mixer.
3
Press POWER to turn on the recorder.
4
Insert an MD.
5
If necessary, turn AMS (or press ./>
repeatedly) to locate the track you want to start
playing from.
If you want to play from the first track, go to step 6.
6
Press 7.
The recorder starts playing.
Operations you may want to do during play
To Press or turn
Stop play x
Pause play 7
Resume play after pausing 7
Locate a succeeding track AMS clockwise (or press >
repeatedly)
Locate the beginning of AMS counterclockwise (or
the current track or press . repeatedly)
a preceding track
Eject the MD After stopping play A
z
To play the MD on which LP2, LP4 stereo recording or MONO
recording has been performed
By pressing 7 in step 6 above, “LP2,” “LP4,” or
“MONO” lights up depending on the mode recorded
on the lower left of the display window.
z
To use headphones
Connect them to PHONES jack. Turn PHONE LEVEL
to adjust the volume.
Playing MDs
This chapter explains the various ways to
play MDs.
28
Playing MDs
z You can adjust the analog signal output level.
1 While the recorder is playing, press LEVEL/DISPLAY/
CHA (or DISPLAY) repeatedly until the line output
adjustment display appears.
2 Turn AMS (or press LEVEL +/_ repeatedly) to adjust
the output signal level.
z You can use Setup Menu to adjust the analog output level
1 Press MENU/NO twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) to select
“Output Level,” then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) to adjust the
output level, press AMS or YES.
4 Press MENU/NO.
z You can make EJECT not function during play or pause to
avoid ejecting the MD by mistake.
1 Press MENU/NO twice during stop.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) to select
“Play Pause,” then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) to select “Z
Disable,” then press AMS or YES.
4 Press MENU/NO.
To function EJECT, select “Z Enable” in step 3.
29
Playing MDs
Playing a Specific Track
While the recorder is playing, pause or stopped, use the
procedure below to quickly play any track.
12345
678910
11 12 13 14 15
16 17 18 19 20
21 22 23 24 25
M.ACCESS
CONTINUE SHUFFLE PROGRAM
NAME CHAR
RM-DR1J
NUM
>
25
AMS
NUMBER BUTTONS
>25
M.SCAN
/ (AMS)
Locating a track with AMS*
To go to Do the following:
The next or a succeeding Turn AMS clockwise (or press
track during play > repeatedly).
A preceding track Turn AMS counterclockwise
during play (or press . repeatedly).
The beginning of the Turn AMS counterclockwise
current track during play (or press . once).
A specific track while the 1 Turn AMS (or press ./
recorder is stopped > repeatedly) until the
track number appears in the
display.
2 Press AMS or 7.
* Automatic Music Sensor
z To locate the last track of the MD quickly
While the recorder is stopped, turn AMS
counterclockwise (or press . once).
z If you locate a track while the recorder is stopped or paused
The recorder will still be stopped or paused at the
beginning of the located track.
Playing a track by entering the track
number Z
Press the number button(s) to enter the track number of
the track you want to play.
To enter a track number over 26
1 Press >25.
See the examples below for the number of presses.
2 Enter the corresponding digits.
To enter 0, press 10 instead.
Examples:
• To play track number 30, press >25, then 3 and 10.
• To play track number 108, press >25 twice, then 1, 10,
and 8.
z If you enter a track number while the recorder is paused
The recorder will be paused at the beginning of the
track.
Locating a point by monitoring the
beginning of each track Z (Music Scan)
If M.SCAN is pressed during stop, the beginning of each
track is played sequentially only at the set fix time.
Press H for the track you want to monitor.
z You can adjust the play time for the beginning of a track by
MUSIC SCAN
1 Press MENU/NO twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) to select
“Music Scan,” then press AMS or YES.
3 Turn AMS until the desired time of 6 to 20 seconds
appears in the display, then press AMS or YES.
4 Press MENU/NO.
30
Playing MDs
Reserving the next track during play
(Next Track Play)
A desired one track can be reserved for the next track by
turning “Next Tr Play (Next Track Play)” of “Setup Menu”
to “On.”
1 Press MENU/NO twice during stop.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) to select
“Next Tr Play,” then press AMS or YES.
3 Turn AMS to select “On,” then press AMS or YES.
4 Press MENU/NO.
5 Press 7.
6 Press DISPLAY/LEVEL/CHAR until the reservation of
the next track to play appears.
7
Turn AMS (or press ./> repeatedly) to select a
track number to be reserved in the flashing track
number display, then press AMS. After reservation,
the flashing of the track number stops.
8
When the play of the track number reserved in step
7 starts, the flashing of the track number display
starts again. Repeat the operation in step 7 to
reserve the next track number.
Notes
• Tracks cannot be reserved when PLAY MODE is
PROGRAM, SHUFFLE, or M.ACCESS.
• The reserved track cannot be located by AMS.
If AMS is turned, the reserved track is canceled, a mode
is set to select a new reserved track.
Locating a Particular Point
in a Track
You can locate a particular point in a track during play or
play pause.
Locating a point while monitoring the
sound (Search)
Press down m/M during play.
You will hear intermittent playback as the disc goes
forward or in reverse.
When you reach the point you want, release the button.
Notes
• If the disc reaches the end while you’re pressing M, the
recorder stops.
• Tracks that are only a few seconds long may be too short
for monitoring. For such tracks, play the MD at normal
speed.
Locating a point by observing the time
indication (High speed search)
Press down m/M during play pause.
You won’t hear playback.
When you reach the point you want, release the button,
then press 7.
z When “- Over -“ appears in the display
The disc has reached the end while you’re pressing
M. Turn AMS counterclockwise (or press .) or
press m to go back.
To Next Page
Loading...
