Setting up the remote commander
Inserting the batteries
Insert two size AA (R6) batteries
by matching the + and - on the
batteries to the diagram inside the
battery compartment.
Insert the negative (-) end first,
then push in and down until the
positive (+) end clicks into position.
Using the remote commander Remote sensor
You can use this remote
commander to operate this VCR
and a Sony TV or AV receiver.
Buttons on the remote
commander marked with a dot
(,) can be used to operate your
Sony TV.
The RECEIVER VOL +/- and
MUTING buttons can be used to
operate your Sony AV receiver.
®
'O_'_
RECEIVERVOL +/-
MUTING
To operate
the VCR
a Sony TV
or AV receiver
Set __/_ to
and point at the remote sensor on the VCR
_IRECEIVER) and point at the remote sensor on the TV or AV
receiver
continued
Getting Started I 5
To Next Page
Loading...
