Searching for a selected point on the tape (continued)
To cancel searching
Press _ PLAY or • STOP,
To turn off the bar indication
Press DISPLAY again.
Notes
• The figure on the bar indication represents the total time length of the inserted tape
as shown below.
The total time length may not be displayed correctly for:
- tapes other than T-60, T-120, or T-160
- tapes recorded in more than one tape speed mode.
Total time length
Tape type
SP LP EP
T-60 or shorter 60 120 180
from T-80 to T-140 120 240 360
T-160 or longer 160 320 480
• If you move the pointer (V) on the bar indication during search, the VCR searches
for the new reset point.
• With the bar indication on, the b.l_ FF/=,_ • and .91_6_ REW/_". buttons onAhehe
remote commander work only for moving the pointer (V), while the _ FF and
REW buttons on the VCR are used for normal tape operation, Note, however, if
you press these buttons _n the VC_ searching is canceled.
84 Additional Operations
To Next Page
Loading...
