Step 2: Setting up the remote commander (continued)
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not use different types of batteries.
• Some Sony AV receivers may not be operated with the remote commander.
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer's code
number.
1
2
Set _]_EIVE_/_ at the top of the remote commander to
_[RECEIVER].
Hold down I/V, and enter your TV's code number(s) using the number
buttons. Then release I/(_.
Now you can use the I/_, VOL +/-, CH +/-, and TV/VIDEO buttons to
control your TV. You can also use the buttons marked with a dot (.) to
control a Sony TV. To control the VCR, reset _]_/_VIDEO_to
61 Getting Started
To Next Page
Loading...
