To Next PageTo Next PageWhy is Dolby Digital not working on my Sony STR-DB1070 Stereo Receiver?
If you're not getting Dolby Digital or DTS multi-channel sound from your Sony Stereo Receiver: * Check that the DVD, etc. being played is recorded in Dolby Digital or DTS format. * When connecting the DVD player, etc. to the digital input jacks of this receiver, check the audio setting of the connected component.
Why can't I tune into radio stations on my Sony STR-DB1070 Stereo Receiver?
If you're unable to tune into radio stations on your Sony Stereo Receiver: * Check that the antennas are connected securely. * If the signal strength of the stations is too weak, use direct tuning. * Make sure you set the tuning interval correctly. * Note that no stations have been preset or the preset stations have been cleared. * Press DISPLAY so that the frequency appears in the display.
Why is there no picture on my TV from my Sony STR-DB1070?
If there is no picture or an unclear picture appears on the TV screen or monitor connected to your Sony Stereo Receiver: * Select the appropriate function on the receiver. * Set your TV to the appropriate input mode. * Move your TV away from the audio components.
Why can't I record with my Sony STR-DB1070 Stereo Receiver?
If you are unable to record with your Sony Stereo Receiver: * Check that the components are connected correctly. * Select the source component with FUNCTION control. * When recording from a digital component, make sure the INPUT MODE is set to ANALOG 2CH FIXED before recording. * When recording from a digital component, make sure the INPUT MODE is set to COAXIAL FIXED or OPTICAL FIXED before recording.
Why is RDS not working on my Sony STR-DB1070 Stereo Receiver?
If RDS is not working on your Sony Stereo Receiver: * Make sure that you’re tuned to an FM RDS station. * Select a stronger FM station.
General| Brand | Sony |
|---|---|
| Model | STR-DB1070 |
| Category | Stereo Receiver |
| Language | English |
Explains how to select the desired component or source.
Guide to choosing pre-programmed surround sound fields.
Diagram and notes for connecting AM/FM antennas.
Diagrams for connecting turntables, CD players, and tape decks.
Diagrams for connecting TVs, DVD players, and camcorders.
Diagrams for connecting DVD players and satellite tuners digitally.
Connecting DVD players or decoders for multi channel audio.
Diagrams for connecting front, surround, and center speakers.
Procedure to reset all settings to factory defaults.
Guide to setting speaker size, distance, and position.
Verifies correct component connections after setup.
How to use the FUNCTION control to select sources.
Customizing sound field settings like effect level and reverb.
Adjusting the volume balance for each speaker.
Fine-tuning sound with equalizer settings for each speaker.
Entering custom names for stations and sources.
Steps for recording audio from the receiver.
Steps for recording video from sources like VCR or LD.
