Speaker System Hookup
This receiver corresponds with 6. l channel decoding. If
you do not place a center speaker, you can place a rear
center speaker. For details, see page 18.
Speakercords (notsupplied)
COnefbr each fiont, reai. and center speaker
(+) _ _ (+)
(-) _ _ (-)
Monaural audio cord (notsupplied)
One for an active sub woofer
Black _ _ Black
FRONT
SPEAKERS B
@
@
Front speaker (R)
IMPEDANCE USE 4-I _)
R REAR L CENT£R
Front speaker (L)
IMPEDANCE
SELECTOR
O
O
5'
r-
"o
D.
€0
5'
r-
"o
€0
"o
¢D
_0
@ @
Active sub woofer
Rear speaker (R)
Connect the To the
Front speakers (8 or 4_)ohm) SPEAKERS FRONT A terminals
Additional pair of fi'ont SPEAKERS FRONT B terminals
speakers (8 or 41)ohm)
Rear speakers (8 or 41)ohm) SPEAKERS REAR terminals
Center speaker or rear center SPEAKERS CENTER terminals
speaker :_)(8or 4_)ohm)
Active sub woofer SUB WOOFER PRE OUT _)
_) See "Speaker impedance" on d_e nex_ page.
_) You can connect an active sub woofer to either of the _woja&s. The
remainiz_gjack can be used ro connect a second active sub woofe1:
J> If ?vu do not use a center speaker; ?_)u can connect a rear center
speaker: For derails, see page !&
@ @
Rearspeaker (L)
@ @
Center speaker
(Rear center speaker)
"_;_To connect certain speakers to another amplifier
Use the PRE OUT jacks. The same signal is output fl'om both the
SPEAKERS jacks and the PRE OI,IT jacks. For example, if you
want to connectjust the front speakers to another amplifier,
connect that amplifier to the PRE OUT FRONT L and R jacks.
• Twist the stripped ends of the speaker cords about
2/3 inch (10 ram). Be sure to match the speaker cord to
the appropriate terminal on the components: + to + and
to . If the cords are reversed, the sound will be
distorted and will lack [)ass.
• If you use fl'ont speakers with low maximum input
rating, adjust the wdume caref\flly to awfid excessive
output on the speakers.
15
To Next Page
