Unpacking
Check that you received the following items with the unit:
• FM wire antenna (1)
• AM loop antenna (1)
• Remote commander RM-TP504 (remote) (1)
• LR(; (size-AA) alkaline batteries (4)
• Coin shaped lithium battery (CR-2032) (1)
Models of area code UC only
• Audio/video/control S connecting cord (1)
• Control S connecting cord (1)
• Remote commander RM-US104 (remote) (1)
• R6 (size-AA) batteries (2)
Insert batteries with the + and properly oriented in the
battery compartment. When using tile remote, point it at
the remote sensor _ on tile receiver
For details, refer to the operating instructions supplied
with your remote.
"_" Whento replace batteries
Under normal conditions, the batteries should last for about
3 months. When tbe remote no longer operates the receivei;
replace all batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or humid place.
• Do not use a new batte W with an old one.
• Do not expose the remote sensor to direct stmlight or lighting
apparatuses. Doing so may cause a mall\ruction.
• If you don't use the remote fur an extended period of time,
remove the batteries to avoid possible damage fl'om battery
leakage and corrosion.
• The remote RM TP504 is designed fur use with alkaline
batteries only. Do not use a combination of difterent battery
types.
• Turn off the power to all coinponents [)eft)re making
any connections.
• Do not connect the AC power cord until all of the
connections are coinpleted.
• Be sure to make connections firnfly to avoid hum and
noise.
• When connecting an audio/video cord, be sure to
match the color-coded pins to the appropriate jacks on
the components: yellow (video) to yellow; white (lefL
audio) to white; and red (right, audio) to red.
To Next Page
Loading...
