You can tune ill stations on this receiver in tile following
ways:
Automatic FM Memory (AUTOBETICAL)
-Models of area code CED only
You can have the receiver automatically store up to 30 of
tile clearest FM and FM RDS stations in alphabetical order
(see page 46).
Direct Tuning
You can enter a frequency of the station you want directly
by using tile nui-fleric buttons on tile supplied remote (see
page 47).
Automatic Tuning
If you don't know the fi'equency of the station you want,
you call let the receiver scan all available stations in your
area (see page 47).
Preset Tuning
After you have tuned ill stations using Direct Tuning or
Automatic Tuning, you can preset them to the receiver
(see page 48). Then you can tune in ally of the stations
directly by entering its 2-character code using the
supplied remote (see page 48). Up to 30 FM or AM
stations can be preset. The receiver will also scan all the
stations that you have preset (see page 48).
RDS functions
-Models of area code CED only
This receiver also allows you to use RDS (Radio Data
System), which enables radio stations to send additional
information along with the regular program signal. You
call use tile following three convenient RDS features:
Displaying RDS information (see page 49)
Scanning preset stations by prograin type (see page
49)
Using the EON f\mction (see page 49)
Note that RDS is operable only for FM stations.*
* No_ all FM.s_a_ions provide RDS service, nor do _hey provide _he
same _,pes oYservices. If you are no_ &n]iliar wi_h _heRDS services
in your area, check with your local radio s_arions for de_ails.
Before you begin, make sure you have:
• Connected FM and AM antennas to the receiver (see
page 5).
45
w
8
e_
To Next Page
Loading...
