Sony STR-ZA5000ES - Adjusting Settings Network Setup

Checking the network information (Information)
You can check the various settings on the network.
[119] Adjusting Settings
Network Setup
Enabling the network function even when this receiver
is in standby mode (Network Standby)
Note
When the receiver is in standby mode, the (power) indicator on the front panel lights up in amber
if [Network Standby] is set to [On].
The top of the cabinet may become hot. This is because part of the circuit(s) inside the receiver
is(are) still turned on, and is not a malfunction.
[120] Adjusting Settings Network Setup
Enjoying Hi-Fi System sound (Music Connect)
You can configure settings to enable the receiver to link with a Hi-Fi System device.
Note
For details on how to configure settings for this function, consult your nearest Sony dealer.
[121] Adjusting Settings Audio Setup
Playing audio signals with high-quality sound (Digital
Legato Linear (D.L.L.))
The D.L.L. function is a technology developed by Sony that allows low-quality digital and analog
Select [Setup] - [Network Setup] from the home menu.
1
Select [Information].
You can check the settings (*) for [Connection Status], [Internet Access], [IP Address
Setting], [IP Address], [Subnet Mask], [Default Gateway], [DNS Settings], [Primary DNS],
[Secondary DNS] and [MAC Address].
2
The setting items during setup differ depending on the network environment and connection type.
*
Select [Setup] - [Network Setup] from the home menu.
1
Select [Network Standby].
2
Set to [On] or [Off].
On: The network function works even when the receiver is in standby mode, and the
receiver resumes operation when controlled over the network.
Off: The network function turns off when the receiver is in standby mode. The receiver
takes more time to resumes operation when powered on again.
3
Select [Setup] - [Network Setup] from the home menu.
1
Select [Music Connect].
2
Select the setting you want.
Connected Device: Select the connected device to enable the function. Select
[Remove Connected Device] to disable the function.
Input for Music Connect1: Select the input to link with.
Preset Volume: Preset the volume level.
Output Zone: Select the zone to which you want to output sound.
Connected Device: Select the connected device to enable the function. Select
[Remove Connected Device] to disable the function.
Input for Music Connect2: Select the input to link with.
Preset Volume: Preset the volume level.
Output Zone: Select the zone to which you want to output sound.
3