[Auto Calibration] has not been performed.
The receiver may play signals at a lower sampling frequency than the actual sampling frequency of
the input signals, depending on the audio format.
[99] Adjusting Settings Speaker Setup
Selecting the Auto Calibration type (Calibration Type)
You can select a calibration type after you have performed the Auto Calibration and saved the
settings.
Note
This function does not work when [Direct] is being used and an analog input is selected.
The receiver may play signals at a lower sampling frequency than the actual sampling frequency of
the input signals, depending on the audio format.
[100] Adjusting Settings Speaker Setup
Checking the speaker position and the corresponding
speaker terminals (Speaker Connections)
This function lets you know the position of the speaker you select and the corresponding
speaker terminals on the receiver to which the speaker should be connected.
[101] Adjusting Settings
Speaker Setup
Selecting the speaker pattern (Speaker Pattern)
You can select the speaker pattern according to the speaker system which you are using.
[102] Adjusting Settings
Speaker Setup
Assigning the surround back speaker terminals (SB
Speaker Assign)
You can set the assignment for the SPEAKERS SURROUND BACK (FRONT B/BI-AMP/ZONE
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Calibration Type].
2
Select the setting you want.
Full Flat: Makes the measurement of frequency from each speaker flat.
Engineer: Sets to “the Sony listening room standard” frequency characteristics.
Front Reference: Adjusts the characteristics of all of the speakers to match the
characteristics of the front speaker.
Off
3
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Speaker Connections].
2
Select the speaker you want from the list on the right side of the screen
The position of the speaker and the corresponding terminals on the receiver to which the
speaker should be connected are shown on the screen.
3
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Speaker Pattern].
2
Select the speaker pattern you want.
3
To Next Page
Loading...
