82
Controller Menu
Chapter 3 Menu
Network
Location Sets the location information.
When the item is selected, you can enter a new name.
New Name: Enter a new name (up to 20 characters).
Trap Sets the address to send the information.
Mode Sets the settings to send information manually or automatically ([Manual] or Auto).
This item cannot be selected when the monitor is controlled with BKM-15R or BVM-A14F5.
Trap Address Setting Sets the IP address to send the information. [000.000.000.000]
When Mode is set to Manual or the monitor is controlled with BKM-15R or BVM-A14F5, you
can select this item.
When the item is selected, you can set the IP address of Trap1 to Trap4.
When the monitor is controlled with BKM-15R or BVM-A14F5, you can set only the IP
address of Trap1 and Trap2.
Cancel: Cancels the changed or confirmed setting.
Confirm: Saves the changed or confirmed setting.
Trap Address Status Displays the IP address to send the information.
When Mode is set to Auto, you can select this item.
This item cannot be selected when the monitor is controlled with BKM-15R or BVM-A14F5.
When the item is selected, the IP address of Trap1 to Trap4 is displayed.
Reset Mode/Address Resets the settings to send information manually or automatically and the IP address to the
factory setting.
This item cannot be selected when the monitor is controlled with BKM-15R or BVM-A14F5.
When the item is selected, the following message appears.
Are you sure?
OK: To reset the data, press the ENTER (Ent) button.
Cancel: To cancel, press the MENU button.
Authentication Sets whether or not to issue the authentication ([Disable] or Enable).
This item cannot be selected when the monitor is controlled with BKM-15R or BVM-A14F5.
Community Sets the community name.
This item cannot be selected when the monitor is controlled with BKM-15R or BVM-A14F5.
When the item is selected, you can enter the community name (up to 20 characters).
public: Initially, public is entered automatically. Enter any character after it.
New Name: Enter a community name.
Protocol Setting Sets the required items for communications such as the port number.
This item cannot be selected when the monitor is controlled with BKM-15R or BVM-A14F5.
For the setting value, consult the network administrator.
SDCP/SDAP Community Sets the SDCP/SDAP community name.
When the item is selected, you can enter the community name (four characters).
SONY: SONY is entered as a community name.
New Name: Enter a new name.
SDCP Port No Sets the SDCP port number.
Set to 53434 to 53534. [53484]
SDAP Port No Sets the SDAP port number.
Set to 53812 to 53912. [53862]
SDAP Broadcast Sets whether or not to issue the SDAP (Disable or [Enable]).
SDAP Broadcast Period Sets the period (seconds) to issue the SDAP.
Set to 05 to 30. [30]
Reset Protocol Setting Resets the protocol setting.
When the item is selected, the following message appears.
Are you sure?
OK: To reset data, press the ENTER (Ent) button.
Cancel: To cancel, press the MENU button.
Function Key Assigns the function to the function buttons of the controller.
This item cannot be selected when the monitor is controlled with BKM-15R or BVM-A14F5.
For details on the function assignment, see “Assigning a Function to a Function Button” (page
100).
Menu Function and operation ([ ]: factory setting)
To Next Page
Loading...
