Installing and Connecting the Projection TV
27
Installing and Connecting the Projection TV
Connecting a Digital TV Receiver
Disconnect all power sources before making any connections.
1
Using three separate component video cables, connect the Digital TV
Set-top box’s Y, PB
and P
R
jacks to the projection TV.
2
Using an audio cable, connect the Digital TV Set-top box’s Audio OUT
jacks to the projection TV’s AUDIO IN jacks.
✍
The Y, P
B
and P
R
jacks do not provide audio, so audio cables must
be connected to provide sound.
Component video connection is necessary to view 480p, 720p and
1080i formats. You may also use the S VIDEO or Composite Video
connections, however, composite video (Y, P
B
, P
R
) will provide the
best picture quality for all format types.
Be sure to read the
Set-top box manual.
z
VMC-10HG (not supplied)
Digital TV Set-top box
RK-74A (not supplied)
AUDIO-R (red)
AUDIO-L (white)
Rear of
projection TV
P
R
P
B
Y
✍
You cannot record the signal from any equipment connected into the
Y, P
B
and P
R
connectors.
✍
This projection TV is not compatible with digital TV receivers
configured with RGB or VGA output connectors.
To Next Page
Loading...
Need help?
General
