Using the Remote Control
5
Programming the Remote Control
In order to use your remote control with other equipment, you need to program your remote
control. Use the following procedure to program the remote control.
1 Check the list of “Manufacturer’s Codes” on page 6 and find the three-digit code number
for the manufacturer of your component. If more than one code number is listed, use the
number listed first.
2 Press .
3 Press or on the button bar to indicate the type of component you want to
program with the remote control.
4 Use the buttons to enter the three-digit manufacturer’s code number.
5 Press .
6 To check if the code number works, aim the TV’s remote control at the component and
press on the green POWER button that corresponds with that component. If it responds,
you are done. If not try using another code listed for that manufacturer.
✍ The and button will flash when you press .
✍ You must do step 4 within 10 seconds of step 3, or you must redo steps 2 and 3.
✍ If you have problems programming your remote control, see “Other Information” on page 45.
0 9
01US04BAS-BR.fm Page 5 Tuesday, February 4, 2003 3:23 PM
To Next Page
Loading...
