Connecting and Installing the TV (continued)
Connecting an audio system Disconnect all power sources before making any connections.
For greater viewing pleasure, integrate your
home stereo into the system.
| Using AUDIO connectors, connect AUDIO
OUT on your TV to one of the unused Line
inputs (e.g. Tape-2, etc.) on your stereo
(White-AUDIO Left, Red-AUDIO Right).
2 Set your stereo to the chosen Line input
and refer to page 14 of this manual for
additional audio setup instructions.
(Rear of TV)
VHF/UHF
Vl0EO IN
1
AUDIO-L (white)
AUDIO-R (red)
RK-74A
(not supplied)
1
Line _ _
2 /1: o[11 1
Connecting a camcorder
• KV-27V22, 29V22M only
This connection is convenient for viewing a
picture directly from your camcorder.
Using AUDIO/VIDEO connectors, connect
AUDIO and VIDEO OUT on your camcorder
to AUDIO and VIDEO IN on the front panel
of your TV (Yellow-VIDEO, White-AUDIO
Left, Red-AUDIO Right).
Note:
* If you are connecting a monoaural camcorder,
connect only the single audio output to the left
input on your TV.
R
If you have an S video equipped camcorder, you
can use an S video connection for optimum
picture quality. (KV-27V22, 29V22M only)
U U ,
vlmEO 2 INPUT
w_oN
VIDEO (yellow)
AV output
VMC-810S/820S
(not supplied)
m
(red)
(white)
To Next Page
