_J_ _ Basic Set up
Inserting batteries
Insert two size AA (R6) batteries (supplied) by
matching the + and - on the batteries to the
diagram inside the battery compartment.
Using the remote control
Select buttons
VOL CH
Select
On Line Help/Instructions
Several menu windows will provide prompts
and instructions to assist you in navigating
through the different functions. When
presented, use these to supplement the instructions
in this manual.
Notes:
• Remove the batteries to avoid damage
from possible battery leakage whenever
you anticipate that the remote control will
not be used for an extended period.
• Handle the remote control with care.
Avoid dropping it, getting it wet, or
placing it in direct sunlight, near a heater,
or where the humidity is high.
• Your remote control can be programmed to
operate most video equipment. See page 18.
The supplied remote control has select
buttons which allow for movement of the on-
screen selector in four directions. Pressing on
the edge of the select buttons will cause the
selector to move in the selected direction.
Pressing the center of the select buttons "GD"
will activate the selected item.
Adjusting sliders
When menu items present a slider ( _ or
_), use the select buttons (€ or _) to adjust
the setting.
To Next Page
