71
Troubleshooting
On-screen display
does not appear.
The on-screen display does not appear when
“Status” in the Operation menu is set to “Off.”
33
The aspect ratio of
the display is not
right/the image is
displayed smaller /a
portion of image
does not appear.
The image may not display correctly because the
input signal cannot be judged correctly. In this case,
set “Aspect” manually.
6, 28,
30
The image is a
trapezoid.
The images become trapezoidal because of the
projection angle. In this case, you can correct the
trapezoidal distortion, using a Keystone feature.
6, 20,
38
Edges of the image
are cut off or dark.
If you use the lens shift function with a setting
outside the recommended range, edges of the
image may be cut off or appear dark. Use a setting
within the normal range for the lens shift function.
81
The image is
distorted.
Warping is set.
Disable the warp correction feature.
22, 38
The image is dark/
too bright.
The settings for “Brightness,” “Contrast,” and “Light
Output Mode” affect brightness of the image. Check
if the value is appropriate.
26, 35
“With Static Signal” is set to “On.” 36
When video signal is not input, the light is dimmed
to reduce power consumption.
35
When the temperature around the unit is high, the
brightness will be reduced to protect the unit.
–
The image is not
clear.
Check if the projector is in focus. 18
The picture will not be clear if condensation has
accumulated on the lens. In this case, let the
projector sit for about two hours with the power on.
–
The image is noisy. Check if the connecting cable is connected to the
external equipment properly.
9
No sound. Check that the connecting cables between the
projector and external video or audio equipment are
securely connected.
9
Check if the external audio equipment is set
properly.
–
Audio is not output if “Speaker” is set to “Off.” 31
Audio is not output if audio muting is activated. 6
Check if the volume is not set to minimum. 6, 31
Symptoms Remedy Page
To Next Page
Loading...
