833 User Guide
41
CL-12 Selects CL-12 menu.
1. L-X2 Level Controls: sets whether the L-X2 pots control bus level or
output level or whether they are disabled altogether.
2. L-X2 Metering: sets whether the L-X2 meters display bus or output
levels.
3. L-X2 Routing: sets whether L-X2 routing is to buses L-X2 or outputs
L-X2.
4. LED Brightness: sets CL-12 LED brightness
5. SEL Follows PFL: selects whether a channel is automatically select-
ed when its PFL is engaged.
CL-12 CONTROLLER
12 channel linear fader controller with control over fader gain, PFL,
Arm, EQ, buses, outputs, coms, transport, metadata, and more. For
detailed setup and operational information, please refer to the
CL-12
User Guide.
Tips:
When CL-12 is connected to the 833, trim gains are controlled from
the 833.
Slate mic can be toggled on/off by pressing both COM 1 and COM 2
simultaneously.
When adjusting EQ from the CL-12, the EQ values are displayed at the
bottom of the meter view.
A USB-A to USB-A cable is required to connect the CL-12.
Supported Third-party Controllers
The 833 supports some third-party external controllers that conform
to the MCU protocol.Two controllers may be connected simultaneously
for extended control. The CL-12 Linear Fader Controller cannot be
used with another control surface.
SONOSAX SX-LC8+ Eight channel compact fader bank with faders
and channel selects for channels 1-8 plus controls for slate mic,
record, and stop. The Mic, Rec, and Stop buttons are mappable to
other functions using the Mapping menu.*Only one LC8+ can be
connected.
Ensure the Sonosax is set to USB Midi mode
1. Press and hold buttons 6 + 7 + 8 and connect the USB cable to the
8-Series USB-A port. The mode change is conrmed by a blinking REC
2. Reboot the 8-series.
ICON PLATFORM M+ AND D2 DISPLAY Eight channel fader bank
with control over gain, bus, sends, coms, trim, and pan. Dedicated
Select, Mute, Solo, and Arm buttons for each channel.
ICON PLATFORM X+ Eight channel fader bank with single assign-
able knob and Select, Mute, Solo, and Arm buttons.
ICON PLATFORM B+ Assignable illuminated 50 pad button surface.
Connects via USB-A cable, not mini DIN.
BEHRINGER X-TOUCH Eight channel trim and fader panel with
master volume and additional mappable buttons.
MACKIE MCU PRO Eight channel trim and fader panel with master
volume and additional mappable buttons.
In addition, any MCU controller may have its buttons custom-mapped
to perform any of the following actions on 833:
To Next Page
Loading...
Need help?
General
