Sourcetronic ST2683A - MEAS SPEED; RANGE SET; LOCK RANGE

ST2683A Operation Manual Ver.1.3
12
Steps for setting the WAIT TIME, MEAS TIME and DICH TIME are the same as CHAR TIME. The
setting range of CHAR TIME, WAIT TIME, MEAS TIME and DICH TIME is 0~999s. When the time is
set to 0s, the step is skipped (details for measurement procedure please refer to 3.4.2). During
DICH time, the discharge current is limited by the 1kΩ charge resistor and a maximum of 5mA. At
the end of MEAS TIME, the last measured value is held and displayed.
3.2.4 MEAS SPEED
This function is used for setting the measurement speed of the instrument.
Steps for setting the MEAS SPEED:
Touch the corresponding zone. The following items will be displayed in the soft key zone.
 FAST
It is used for setting the MEAS SPEED as FAST.
 SLOW
It is used for setting the MEAS SPEED as SLOW.
Touch the corresponding key in soft key zone to select the relevant function.
3.2.5 RANGE SET
This function is used for setting the range selection mode of the instrument.
Steps for setting the RANGE SET:
Touch the corresponding zone. The following items will be displayed in the soft key zone.
 AUTO
It is used for setting the range selection mode as AUTO.
 LOCK
It is used for setting the range selection mode as LOCK.
Touch the corresponding key in soft key zone to select the relevant function.
3.2.6 LOCK RANGE
This function is used for selecting the lock range of the instrument.
Steps for setting the LOCK RANGE:
Touch the corresponding zone. The following items will be displayed in the soft key zone.
 1mA
It is used for setting the LOCK RANGE as AUTO.
 100UA
It is used for setting the LOCK RANGE as 100µA.
 10uA
It is used for setting the LOCK RANGE as 10µA.
 1uA
It is used for setting the LOCK RANGE as 1µA.
 More