Sourcetronic ST2683A - COMParator Subsystem Commands

ST2683A Operation Manual Ver.1.3
44
Data format: <insulation resistance>, <leakage current>, <ultralimit>
Ultralimit:
0 downlap
1 between the range
2 onlap
AUTO command makes ST2683A to send each measurement result to its output buffer
automatically.
ON
OFF
Command syntax：FETCh:AUTO 1
0
For example: WrtCmd(“FETC:AUTO ON”);
The SMONitor command querys the monitor voltage.
Command syntax：FETCh:SMONitor:VOLT?
7.2.6 COMParator Subsystem Commands
COMParator subsystem commands are used to set the pickout function of the insturment,
including the setup of pickout switch and pickout list.
Command Tree:
The :FUNCtion command is used to set the pickout function as ON or OFF. It can query the
current pickout function state.