Sourcetronic ST2683A - PASSWORD

ST2683A Operation Manual Ver.1.3
22
Touch PASSWORD, the following soft key zone will be displayed:
 OFF
Touch this key to turn off the password protection function. This function would be disabled
only when the preset password is correctly input.
 LOCK SYSTEM
Touch this key to enable the password function. Please input the password which will be
required to be input when opening a file or starting up the instrument.
 LOCK FILE
It is used for file protection of users.
 MODIFY
Touch this key to modify the password.
Steps for modify the password:
Touch MODIFY, a numeric keyboard will pop up then you should input the original password and
press [ENTER] to confirm. Input the new password when the numeric keyboard is shown once again
and press [ENTER] to confirm. Then the numeric keyboard will be displayed for the third time,
please input the new password. Press [ENTER] to finish the password modification.
NOTE: The default password is 2683.
4.1.3 BUS MODE
This function is used for selecting the communication interface.
Steps for setting the bus mode:
1) Touch BUS MODE, the following soft key zone will be displayed:
 RS232C
 USBTMC
 USBVCOM
2) Touch RS232C to select the RS232C interface.
3) Touch USBTMC to select the USBTMC interface. The instrument communicates with PC
through the USB interface (USB DEVICE) on the rear panel.
4) Touch USBVCOM to select the USBVCOM interface. The instrument communicates with PC
through the USB interface (USB DEVICE) on the rear panel.
4.1.4 LANGUAGE
This function is used to set the language.
Steps for setting the language:
Touch LANGUAGE, the following soft key zone will be displayed:
 English
Touch this soft key to set the language as English.
 Chinese
Touch this soft key to set the language as Chinese.