ST2683A Operation Manual Ver.1.3
23
You can touch soft keys to set corresponding functions.
4.1.5 KEYSOUND
This function is used to control the key sound when the users touch the touch screen and press the
machinery keys.
Steps for setting the KEYSOUND:
Touch KEYSOUND, the following soft key zone will be displayed:
ON
Touch this key to turn on the key sound of touch screen.
OFF
Touch this key to turn off the key sound of touch screen.
You can touch soft key zone to set corresponding functions.
4.1.6 TRIGGER
This function is used to select the trigger source of triggering the instrument to test.
Steps for setting the TRIGGER:
Touch TRIGGER, the following soft key zone will be displayed:
MAN
Press the “TEST” key on the panel, the instrument will test a DUT once and display the result.
This mode keeps in waiting mode when it is not used.
EXT
Test a DUT once and display the result when the instrument receives an external “start up”
signal from the footswitch of HANDLER interface or FOOT.C interface on the rear panel and
then enter into the waiting mode again.
BUS
The measurement of the instrument will be triggered through the communication interface.
You can touch soft key zone to set corresponding functions.
4.1.7 BAUD RATE
This function is used to select the baud rate of RS232 interface. The following twelve baud rates
are selectable: 9.60000k, 19.2000k, 28.8000k, 38.4000k, 48.0000k, 57.6000k, 67.2000k, 76.8000k,
86.4000k, 96.0000k, 105.600k and 115.200k.
Steps for setting the baud rate:
Touch BAUD RATE, the following items will be displayed in the soft key zone:
↑（+）
Touch the key to increase the baud rate.
↓（-）
Touch the key to decrease the baud rate.
To Next Page
Loading...