ST2683A Operation Manual Ver.1.3
28
Touch this key, if the file name that the cursor locates is not empty, [YES] and [NO] will be
displayed in the soft key zone. When [YES] is selected, the instrument will load the setup
data in the file; when [NO] is selected, the current operation will be cancelled.
Save
Touch this key, [YES] and [NO] will be displayed in the soft key zone. When [NO] is selected,
the current operation of save file will be cancelled; when [YES] is selected, the numerical
keyboard will pop up and then you can input the file name and press [ENTER] to finish
inputting. Thus the current settings in all pages will be saved to the file. (NOTE: When
storing a file, if the inputting file number has already existed, the save operation will
overwrite the original file.)
Delete
Touch “Delete”, if “YES” is selected, the instrument will delete the file that the cursor
locates.
Copy to E:
Touch “Copy to E”. The instrument will copy the file the cursor locates or the selected file
to a U disk.
Select
Touch “Select”, the file the cursor locates will be selected. ST2683A can simultaneously
copy several files to a U disk.
Touch “Select” once again, the selected file will be cancelled from selection.
Save Measurement Results
In the “MEAS DISP” page, touch “Start Save” in soft key zone to save measurement results to a U
disk. Touch “Stop Save”, the instrument will stop saving measurement results.
Operations of External File and Folder
Operations of external file are similar to that of internal file.
Operations of external file folder are as below:
(1) Touch the name of the desired file folder to enter into the corresponding folder;
(2) Touch “Upper Page” in the right soft key zone to return to the upper page shown as
figure 4-4 above.
To Next Page
Loading...