ST2683A Operation Manual Ver.1.3
34
New Hardware will show on the right bottom of the computer desktop, as is shown below:
Figure 6-3 Procedure 1 of Installing USB Driver
Click “NEXT”, dialogue 6-4 will pop up. Choose “Install the software automatically (recommended)”.
Figure 6-4 Procedure 2 of Installing USB Driver
When the installation of driver is finished, user can see “usb test and measurement device” in the
device manager of PC, as is shown in the following figure.
Figure 6-5 USBTMC Display of PC Device Manager
When user is using USBTMC interface, labview software can be used to access the instrument.
To Next Page
Loading...