Page 7
Safety Instructions (cont.)
3. Extension Cords. DANGER- Improper use of an extension cord will cause death or severe injury.
The GFCI on the machine’s power cord does not protect the operator from electrical shock along
the extension cord.
If an extension cord must be used, it must be of an approved, three-wire construction, equipped
with a three-pronged plug, and in good condition. Replace or repair damaged cords.
Do not use an undersized extension cord. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. Use the following minimum gages depending upon
the length of the extension cord:
-16 Ga. –for cords of less than 100 feet in length
-14 Ga. –for cords of 100 feet to 150 feet in length.
If in doubt, use the next heavier gage. (The smaller the gage number, the heavier the cord.) When
the machine is used outdoors, use only extension cords intended for use outdoors and so marked.
Do not allow an extension cord to be exposed to water.
Don’t assume that all three hole outlets are properly installed. Check the outlet and also the adapter,
if used, with an outlet testing device which quickly indicates if a ground is connected. Correct a faulty
test indication before proceeding.
4. Don’t Abuse Cord. Never move or lift tool by cord or yank it to disconnect from receptacle. Keep
cord from heat, oil and sharp edges.
5. Disconnect Power Cord. When not in use, before servicing, and when changing accessories,
such as blades and cutters.
6. Guard Against Electric Shock. Prevent body contact with grounded surfaces such as pipes,
radiators, ranges, refrigerator enclosures.
7. Avoid Accidental Starting. Don’t move plugged-in tools. Make sure switch is in OFF position
before plugging in power cord.
8. Stay Alert. Watch what you are doing. Use common sense. Do not operate tool when you are
tired.
9. Keep Work Area Clean. Cluttered areas invite injuries.
10. Consider Work Area Environment. Don’t expose power tools to rain. Keep work area well lit.
Do not use tool in presence of flammable liquids or gases.
Avoid operating the machine in areas of standing water.
To Next Page
Loading...
