User manual EXPERT 2K-FA
Pag. 67 of 67 Issue 2 – May 2011
Once the above described steps get completed Term_2K_USB,exe, will only be able to
recognize and address the EXPERT 2K-FA whose (unique) ID String matches to the
one written after the USB_ID: label of the picture above.
As explained earlier, this setting is permanent so, there is absolutely no need to repeat
the acquisition procedure described so far any time the user wants to connect to that
specific EXPERT 2K-FA unit.
Of course the acquisition procedure must be restarted again in case another EXPERT
2K-FA linear amplifier would require to be addressed; that is because another device
has got, by force of circumstances, another ID String parameter to properly reconsider.
After having carried out all the setting and configurations steps listed in the earlier
pages, everything’s ready for using the FT232RL selective addressing features
described so far.
All the operations tied to the C
onnect / Disconnect menu items are still the same as in
the case of non-selective addressing procedure.
A last note.
If, for whatever reason, all the selective addressing capabilities are no longer needed to
open a connection to an EXPERT 2K-FA thru its USB link, they can be temporarily
disabled.
This operation is quite easy to perform.
After having recalled the Configure USB connection dialog form using its specific item
contained into the F
ile menu, uncheck with a mouse click the Enable ID Addressing
option, as shown in the following picture, and validate this entry using the OK button.
To Next Page
Loading...
