Specialized CHISEL - Table of Contents

CONTENTS
1. INTRODUCTION ............................................. 1
1.1. Symbols ................................................1
1.2. Warranty ...............................................1
2. GENERAL INFORMATION ..................................... 2
2.1. Intended Use ............................................2
2.2. Weight Limits ...........................................2
3. GEOMETRY ................................................. 3
4. SPECIFICATIONS ............................................ 5
4.1. General Specifications ....................................6
4.2. Bolt Size / Tools / Torque Specifications .....................8
4.3. Bearing and Spacer Specifications ........................10
4.4. Bolt, Axle, Washer, and Flip Chip Specifications .............12
4.5. Recommended Tire Pressures ............................13
5. ASSEMBLY ................................................13
5.1. Rear Triangle Assembly .................................14
5.1.1 Main Pivot Bearings ...................................15
5.1.2 Link Bearings ........................................15
5.1.3 ICR Funnel and Mudguard ..............................15
5.1.4 Link at Seat Tube .....................................16
5.1.5 Shock at Extension with Flip Chips .......................16
5.1.6 Link at Extension .....................................17
5.1.7 Forward Shock Mount .................................18
5.1.8 Main Pivot ...........................................18
5.1.9 Link at Seatstay ......................................19
5.1.10 Bolt Torquing Sequence ................................19
5.2. Seatpost Minimum / Maximum Insertion ...................20
5.3. Bottom Bracket ........................................20
5.4. Rear Brake Mount ......................................21
5.5. Rear Derailleur Hanger ..................................22
5.6. Headset, Fork, and Stem Assembly ........................23
6. CABLE ROUTING ...........................................25
6.1. Rear Brake (Red) .......................................26
6.2. Mechanical Rear Derailleur (Green) .......................26
6.3. Dropper Post (Blue) .....................................26
6.4. Head Tube ICR Port .....................................26
6.5. Front Brake ............................................27
7. AIR SHOCK SETUP .........................................27
7.1. Setting Air Pressure (SAG) ...............................28
7.2. Adjusting Rebound ......................................29
7.3. Adjusting Compression ..................................29
7.4. Suspension Maintenance ................................29
8. GENERAL NOTES ABOUT MAINTENANCE .....................30
SPECIALIZED BICYCLE COMPONENTS
15130 Concord Circle, Morgan Hill, CA 95037 (408) 779-6229
0000202094_UM_R1_11/23