hold the “SET” button for three seconds.
The hour digit will begin flashing.
Press the “MODE” Button until the
desired number appears. (Hold down
the “Mode” button to scroll quickly)
Press the “SET” button once to set
this number and advance to minutes.
Repeat this process until minutes and
seconds are set to the desired settings.
Press the “SET” button to exit
programming mode. Once the time
interval timer is programmed, press
the “TOP” button to stop and start
the Distance Countdown.
Note: The shortest distance that can
be set is .01 miles/km.
COMPUTER FUNCTIONS
Speedometer (SPEED)
Your current speed is always shown
by the long needle on the LCD screen.
Each needle represents one M/h when
miles is selected and two Km/h when
kilometers is selected. The speed is also
shown on the Digital Display Area
up to 99.9 M/h (99.9 Km/h) with
a resolution of 0.1 M/h (0.1 Km/h)
Average Speed (AVSPD)
Average Speed is always shown by
the flashing long needle on the LCD
screen. The average speed is based
upon the ATM time. The resolution of
the average speed data on the Digital
Display Area is shown in 0.1M/h or
Km/h increments. (See figure 13) The
Average Speed is also shown on the
17
To Next Page
Loading...
