using the new 31.8mm diameter bars,
you will need to purchase the 31.8mm
Handlebar Mount Kit (Specialized
P/N 4812-3100) from your
Specialized dealer. To install the
31.8mm diameter strap onto your
SpeedZone Comp, remove the two
Philips head screws from the bottom
of the computer and push out the
retaining pin with a small screwdriver
or a straightened paperclip. (See fig-
ure 6) Use caution not to lose the pin
once you have removed it. Install the
other mounting strap and reinsert the
pin and screws. To test for proper
installation of the magnet, transmitter
and computer, activate the computer
by pushing the ‘MODE’ (right side)
button. Pick up the front of the bicycle
and spin the front wheel. The “wheel
option” indicator will flash. If it does
not flash, check the sensor and mag-
net alignment. Realign as necessary
until the “wheel option” indicator
flashes while spinning the wheel.
OPERATION AND
PROGRAMMING
When your SpeedZone Comp has
not detected any speed input for 30
minutes, it will enter sleep-mode in
order to conserve battery power.
During sleep mode only the analog
and digital clocks are displayed. The
computer will wake up as soon as
wheel speed is detected. Additionally,
you can wake it up by pushing the
“MODE”, “SET” or “TOP” button
once. In order to operate your com-
puter it must be placed in various
6
To Next Page
Loading...
