“SET” button once to confirm your selec-
tion and exit display language mode.
2. Miles or Kilometers selection
(English only)
Your SpeedZone Comp will record
distance and speed in either miles
(m & m/h) or kilometers (K & Km/h).
Please note that miles can only be
selected when the language setting is
English. All other languages display
only kilometers. (See “Setting the
Display Language” above). To enter
your selection of miles or kilometers,
push the “MODE” button until ODO
appears on the left side of the display
(This is called the odometer mode).
Note: if your display says TRIP, press
the “SET” button once to change to
ODO. Next, hold down the “SET”
button for three seconds. The “Km”
or “m” indicator will begin blinking.
You may now alternate between
miles and kilometers by pressing the
“MODE” button. When the correct
choice is flashing, select it by pressing
the “SET” button. You will now enter
the “Programmable Odometer”
mode. If the odometer setting is
correct push the “SET” button five
times to exit odometer mode. (Other-
wise, see “Setting the Programmable
Odometer” below).
Note: The Speed Indication Bezel
will indicate 0-45MPH on SpeedZone
Comp computers purchased in the
USA and the U.K. and 0-90 Km/h
on computers purchased in all other
countries. Cyclists in the USA and the
U.K. who would like to display their
8
To Next Page
Loading...
