Spectra Precision FOCUS 35 - Page 190

Chapter 5
Maintenance and Repair
Focus 30/35 Service Manual 5 - 60 P/N 79000035_SM, Version 1.5
6 Assembly ACB
board and Rear
panel.
A. Connect cable from
F1K board to ACB.
B. Connect the cable
from Display to
ACB.
C. Mount the ACB
board with 4x
EJOT screws (see
important notes).
Connect the 4
cables from ACB to
MCB and SCK/BT.
D. Connect the cable
to the beeper, pull
the 4 cable to the
opening window
and mount the Rear
Panel with the 6 x
M2 screws.
E. Exchange the
Gasket CU F30 if
necessary.
Screw in crosswise
until the screws
become tight, turn out
one turn and in again.
Repeat the procedure
2-3 times and tight
finally with torque
40Ncm/3,54lbfn.
50Ncm/4,4lbfn
Use torque wrench
TORX T6.
Important: Use
always the new
delivered EJOT
screws together
with the service
part.
Use a torque
wrench TORX T8
Item Performance Action Result Notes