Spectra SAM-3040D - Page 34

34
2
Hardware Installation
Connecting External Serial Ports
YourCOMportmaycomemountedonacard-edgebracket.Installthecard-edge
bracket to an availableslot at the rear of the system chassis then insert the se-
rial port cable to the COM connector. Make sure the colored stripe on the ribbon
cableisalignedwithpin1oftheCOMconnector.
BIOS Setting
ConguretheserialportsintheAdvancedmenu(“UARTConguration”submenu)
oftheBIOS.Refertochapter3formoreinformation.