Spectra T950 - Remove the Side Access Panel

Prepare for the Replacement Remove the Side Access Panel
March 2015 HAX Motor Replacement—Spectra T950 Library
10
Remove the Side Access Panel
Usethefollowingstepstoremovetheaccesspanelfromtheleftsideofthe
libraryasviewedfromthefront.
1. Usea1/8‐inchAllenwrenchorhexscrewdrivertoremovethescrewat
thebottomofthewindowpanel.
2. Whileholdingthepanelsteady,slideituptodisengagethepanelfrom
thehangersonbothsidesofthechassis’opening(threeperside).
3. Liftthepaneloffofthehangers,outandawayfromtheframe.
4. Setthepanelaside.
5. IfyouarereplacingtheHAXmotorinaone‐ortw o‐framelibrary,
repeatthestepsinthissectiontoremovetheaccesspanelfromtheright
side.
WARNING
Risk of electrical shock. Hazardous moving parts. Turn off the power to the library
and disconnect the power cords before accessing the inside of the library.
Figure 8 Remove the screw at
the bottom of the window panel.
Figure 9 Slide the panel
up to disengage the hangers.
Figure 10 Lift the panel out and
away from the frame