Spectra T950 - About This Guide; Intended Audience; Product Status; Related Information

Remove the HAX Motor Unmount the HAX Motor
March 2015 HAX Motor Replacement—Spectra T950 Library
18
One- or two-frame library UsethefollowingstepstoremovetheHAX
beltcover.
a. Fromtherightendofthelibrary,supportthetransporterfrom
underneathandmoveituptheVAXcolumntoallowbetteraccess
totheHAXbeltcover.Usealargebindercliptopinchthetwosides
oftheVAXbelttogether,toholdtheelevatedtransporterinplace.
b. Fromtheleftendofthelibrary,slowlypullstraightupwardonthe
HAXsyncbelt(Figure 17onpage 15)tomovetheVAXcolumn
towardyou,totheleftendofthelibrary.
c. Fromtherightendofthelibrary,carefullyliftofftheHAXbeltcover
andsetitaside.
d. Fromthele ftendofthelibrary,slowlypullstraightdownwardonthe
HAXsyncbelttomovetheVAXcolumntotherightendof thelibrary.
Unmount the HAX Motor
1. (Recommended)Usingafelt‐tipmarker,outlinethepositionofthe
HAXmotormountingbracketontheHAXbelthousing.Thisoutline
willhelpyoucorrectlypositionthemountingbracketlater.
Figure 20 Clamp the VAX belt
to hold the transporter.
Caution
Be careful not to move the HAX sync belt too fast, which could cause the VAX
column to crash into the other end of the library.
Never force the VAX column to move along the Thomson rod. Doing so can
permanently damage it. If it does not glide smoothly, stop immediately. Identify
and then remove any obstruction.