Spectra T950 - Install the HAX Belt Cover

To Next Page

To Previous Page

Install the HAX Motor Install the HAX Belt Cover

March 2015 HAX Motor Replacement—Spectra T950 Library

7. UsingtheHAXsyncbelt(Figure 17onpage 15),slowlymovetheVAX

columnbackandforthalongtheHAXrailandverifythattheHAX

drivebeltmovessmoothlyandstayscenteredonthemotorgear.

Install the HAX Belt Cover

1. PlacetheHAXbeltcoverontheleftHAXrailsegment.

One-or two-frame library

a. MakesurethattheVAXcolumnisallofthewaytotheleft.

b. Fromtherightsideofthelibrary,placetheHAXbeltcoveroverthe

HAXrail.

—OR—

Three-frame or larger library

a. MakesurethattheVAXcolumnisallthewaytothe right.

b. Fromtheleftsideofthelibrary,placetheHAXbeltcoveroverthe

HAXrail.Ifthelibraryhasamulti‐segmentHAXbeltcover,slide

thelipontheendoftheHAXbeltcoverundertheedgeofthenext

sectionofcoverandthenlowerthecoverintoplaceovertheHAX

rail.

Caution

Be careful not to move the HAX sync belt too fast, which could cause the VAX

column to crash into the other end of the library.

Never force the VAX column to move along the Thomson rod. Doing so can

permanently damage it. If it does not glide smoothly, stop immediately. Identify

and then remove any obstruction.

Other manuals for Spectra T950