Spectra T950 - Install the HAX Motor; Prepare the HAX Motor for Installation

Install the HAX Motor Prepare the HAX Motor for Installation
March 2015 HAX Motor Replacement—Spectra T950 Library
19
2. Reachthroughthefrontoftheleft‐mostframeandusea#2Phillips
screwdrivertoremovethefourscrewssecuringtheHAXmotor
mountingbrackettotheHAXbelthousing.
3. Removethemotorthroughthefrontoftheframe.
Note: TakenoticeofwhetherthereisaHAXmotorshimbetween,but
notattachedto,theHAXmotormountingbracketandthebelt
housing.
INSTALL THE HAX MOTOR
UsethestepsinthefollowingsectionstoinstallthenewHAXmotorinthe
library.
Prepare the HAX Motor for Installation
1. Removethereplacementmotorfromitspackaging.
Note: Keepallpackagingmaterialtousetoreturntheoldmotorto
SpectraLogic.SeeReturntheComponentonpage 38.
2. Placethemotoronaworksurfacewiththecablestowardtheleft.
3. Usinga1/4‐inchnutdriver,removethetensioningscrew,ifitis
installed.
4. Laythemotordownonaflatsurfacewiththetensioningspring
standofftowardtheside.
Figure 21 Screws securing the HAX motor. The lower left
screw is not visible.